Solar water heater
We provide Solar Water Heater, Water Heater, Hot Water Heater, Solar Water Heaters, Solar Energy Water Heater, Solar Heat Collector, Hot Collector, Solar Water, Solar Products.
SOLAR KEY MARK and SRCC Certificate
Advantages:
1. Can he operated completely automatic if connect with intelligent controller.
2. Simple structure, easy plug-in installation, can be installed both on flat and inclined roof, and can be used with an auxiliary electric booster as to provide tot water without sunshine.
3. Superior heat preservation ensured by one-off molding polyurethane foam with thickness 50 65mm.
4. Suitable for camping area, holiday residences.
5. Stable and reliable performance, well wind resistance.
6. Meet the mankind healthy bath standard: The material of inner tank is SUS304-2B stainless steel plate; The silica gel ring sealing has a long life against the erosion and it ie not harmful to health.
The Principle of thermosyphon
Because of the larger proportion of hot water than cold water, cold water flows downward and hot water goes upward. The water will be heated continuously between water tank and vacuum tube. In other wards, hot water always floats on cold water.
The hot-water flows to the water tank from the vacuum tubes. Because of the proportion, cold water flows to vacuum tubes from the water tank.
The cold water is heated in vacuum tubes. After it becomes hot water, it flows to water tank again. The water circulates constantly between water tank and vacuum tubes; The cold water in water tank will be hotter and hotter.
Finally, all cold water will be heated to be hot water. This is the heating course of cold water.
TECHNICAL PARAMETERS OF NON-PRESSURIZED SOLAR WATER HEATER
Description
Non-Pressurized Solar Water Heater
Material of out tank
0.31mm zinc-olor Steel
Material of inner tank
Food grade 0.31mmSUS304-2BStainless Steel/0.4mm
Tank insulating layer
50mm high-density polyurethane foamed
Diameter inner/out tank
420/310mm OR 460/360mm
Electrical Heater
1.5kw
Inlet and outlet hole
Male G 1/2, 3/4
Max pressure
0.05 Mpa
Solar collector tube
3.3 Borosilicate glass with / AL/N/AL(Single target) or Triple target.ALN/AIN-SS/CU
Thickness of glass tube
1.6mm
Vacuum tube tightness
P≤0.005 Pa
Absorption
as=0.93-0.96(AM1.5)
Emission ratio
εh=0.04-0.06(80C±5C)
Idle sunning property parameters
Y=220~260m2.C/KW
Average heat loss coefficient
ULT=0.6~0.7W/(m2.C)
Bracket:
Galvanized steel 1.2mm
Structure of tank:
4 holes for air vent,overflow,water inlet and outlet,electric heater
Inquiry Basket (
